Filter
Top Products
SKU 94481 For technical questions, please call 1-800-444-3353 PAGE 10
1. Inspect the air supply Screen that is located in the End Cap (81) before each
use, and clean or replace as necessary. Dirt and water in the air supply Screen
are major causes of pneumatic tool wear. Use a lter in the compressed air
system for better performance and longer tool life. The lter must have adequate
ow capacity for the specic application.
2. Clean the external parts of the Nailer with a clean cloth and mild detergent or
non-ammable solvent. Then, dry.
3. Store the tool in a clean, dry, safe location out of reach of children.
4. CAUTION: All maintenance, service, or repairs not listed in this manual
are only to be attempted by a qualied service technician.
INSPECTION, MAINTENANCE, AND CLEANING
TROUBLESHOOTING
Problem Possible Solutions
Air leak near top of tool. 1. Tighten all screws on the cylinder cap.
2. Have a qualied service technician install a head valve piston set.
Tool does not work. 1. Make sure compressor is set between 70 to 120 PSI.
2. Check all air connections for leaks.
3. Make sure to fully depress the safety sleeve on the workpiece when attempting to re
a fastener.
4. Check for fastener jams. Clear the jam if necessary.
5. Have a qualied service technician check out the tool.
Sluggish operation. 1. Make sure the compressor is set between 70 to 120 PSI.
2. Check all air connections for leaks.
3. Have a qualied service technician install a head valve piston set.
Air leak near bottom of tool. 1. Tighten all screws.
2. Have a qualied service technician replace the bumper or head valve piston set.
Poor return after ring the tool. Have a qualied service technician clean the interior of the tool and/or replace the bumper
or head valve piston set.
Weak driving force. 1. Make sure compressor is set between 70 to 120 PSI.
2. Check all air connections for leaks.
3. Have a qualied service technician clean the interior of the tool and/or replace the
bumper or head valve piston set.
Poor feed. Have a qualied service technician clean the interior of the tool and/or lubricate the
magazine and install a new magazine spring.
Tool jamming too often. Have a qualied service technician clean the interior of the tool and/or lubricate the
magazine and install a new magazine spring.
Anytime any maintenance or repairs are done, FIRST:
1. Disconnect the Nailer from its air supply.
2. Empty the Magazine Assembly (70) completely.
3. Attempt to re the Nailer into a piece of scrap wood to ensure that it is
disconnected and is incapable of ring any Brads.