Filter
Top Products
SKU 94481 For technical questions, please call 1-800-444-3353 PAGE 4
15. Guard against electric shock. Prevent body contact with grounded surfaces
such as pipes, radiators, ranges, and refrigerator enclosures.
16. Replacement parts and accessories. This product is to be repaired and
serviced only by a qualied technician. When this product is serviced, only
identical replacement parts should be used. Use of any other parts will void
the warranty. Only use accessories intended for use with this tool. Approved
accessories are available from Harbor Freight Tools.
17. Do not operate tool if under the inuence of alcohol or drugs. Read warning
labels if taking prescription medicine to determine if your judgement or reexes
are impaired while taking drugs. If there is any doubt, do not operate the tool.
18. Use proper size and type extension cord for an air compressor. If an
extension cord is required, it must be of the proper size and type to supply the
correct current to the compressor without heating up. Otherwise, the extension
cord could melt and catch re, or cause electrical damage to the compressor.
Check your air compressor’s manual for the appropriate size cord. It is also
possible that the use of an extension cord may cause your circuit breaker to trip
or your panel fuse to break. If this happens, either use the compressor without
an extension cord or nd a larger amperage circuit to use.
19. Maintenance. The maintenance outlined in the “Maintenance” section should be
performed regularly. For your safety, this product should be serviced or repaired
regularly only by a qualied technician.
20. Compressed air only. Use clean, dry, regulated, compressed air at between 70
and 120 PSI. Never use oxygen, carbon dioxide, combustible gases, or any
other bottled gases a power source for this tool.
21. Do not load brads with the trigger or safety depressed. Unintentional
ring may occur. Do not load brads when the air hose is connected to the
tool. Always assume the tool contains brads.
22. Disconnect air supply before loading the Nailer. Before reloading (or making
any adjustments to) the Nailer, make sure the compressed air is disconnected.
23. Fire brads into an appropriate work surface only. Do not attempt to re
brads into surfaces too hard to penetrate. Do not drive brads on top of other
brads, or at too steep an angle. Brads can ricochet, causing personal injury.
Never re the Nailer into the air, or point it toward yourself or another person.
Always wear ANSI approved impact safety goggles during use, maintenance, and
reloading.
24. Do not re brads too close to the edge of a workpiece. They may split the