Filter
Top Products
Page 8SKU 98676 For technical questions, please call 1-800-444-3353.
least the minimum wire size required.
(See Table A.)
If you are using one extension cord 4.
for more than one tool, add the
nameplate amperes and use the sum
to determine the required minimum
cord size. (See Table A.)
If you are using an extension cord 5.
outdoors, make sure it is marked with
the sufx “W-A” (“W” in Canada) to
indicate it is acceptable for outdoor
use.
Make sure the extension cord is prop-6.
erly wired and in good electrical con-
dition. Always replace a damaged
extension cord or have it repaired by
a qualied electrician before using it.
Protect the extension cords from 7.
sharp objects, excessive heat, and
damp or wet areas.
RECOMMENDED MINIMUM WIRE
GAUGE FOR EXTENSION CORDS*
(120/240 VOLT)
NAMEPLATE
AMPERES
(at full load)
EXTENSION CORD
LENGTH
25’
50’
75’
100’
150’
0 – 2.0 18 18 18 18 16
2.1 – 3.4 18 18 18 16 14
3.5 – 5.0 18 18 16 14 12
5.1 – 7.0 18 16 14 12 12
7.1 – 12.0 18 14 12 10 -
12.1 – 16.0 14 12 10 - -
16.1 – 20.0 12 10 - - -
TABLE A
* Based on limiting the line
voltage drop to ve volts at
150% of the rated amperes.
SYMBOLOGY
Double Insulated
Canadian Standards Association
Underwriters Laboratories, Inc.
V~
Volts Alternating Current
A
Amperes
n
0
xxxx/min.
No Load Revolutions per Minute
(RPM)
SPECIFICATIONS
Electrical
Requirements
120 V~ / 60 Hz
Power Cord: 18 AWG X 3C
9.6 No Load Amps
Lathe Type Wood Cutting
Motor 1.0 HP
Motor Speed 1720 RPM
Spindle Speeds
(RPM)
670, 840, 1040, 1230, 1480, 1650, 1770,
2100, 2420, 2900
Spindle Taper MT-2
Spindle Thread 1” Diameter x 8 TPI x 7/8” Long
Headstock
Adjustments
Rotates at 0°, 60°, 90°, 120°, 180°
Tail Stock
Quill Travel
2-7/16”
Tail Stock
Quill Taper
MT-2
Tool Rest Travel 1-7/16”
Swing Over Bed 14-5/8”
Drive Method Belt & Pulley
Belt Type 0-625 V-Belt
Accessories
3mm, 4mm, 6mm Hex Wrenches (1 ea.)
Dead Center (Qty. 1)
Faceplate (Qty. 1)
Flat Wrenches (Qty. 2)
Net Weight 282.2 Pounds