Filter
Top Products
Page 7- SKU: 98870
Installing the Electrode Handle
Figure 3. Installing the
Electrode Handle
Locate the ELECTRODE CABLE (5), as shown in the parts diagram, and the Elec-
trode Handle as shown in gure 3, Step 1 above.
Slide the Handle Grip off the Electrode Handle, as shown in Step 2 above.
Insert the ELECTRODE CABLE (5) through the Handle Grip, and attach to the Elec-
trode Handle as shown in Step 3 above. Note: You must place bare end of ELEC-
TRODE CABLE wire into opening in end of Electrode Handle, then by tightening the
Screw, tighten the Clamping Plate onto the bare end of the ELECTRODE CABLE,
clamping it securely into place.
With the ELECTRODE CABLE secured into the Electrode Handle, slide the Handle
Grip over the wire connection, as shown in Step 4 above. Tighten the Handle Grip
securely in place by tightening the screw in the base of the Handle Grip, as shown.
WARNING! Never use your welder if the Insulating Handle Grips are not in good condition
and securely in place. Dangerous potentially fatal shocks can result from improper
handle insulation.
1.
2.
3.
4.