Filter
Top Products
3
598-1316-03
4. Plug the solar panel cable into the side of the
sensor housing. Note: Allow extra cable to hang
below the sensor housing for water to drip off
cable (drip loop).
IMPORTANT: Allow the batteries to charge
with two days of sunshine before testing.
RECHARGEABLE
ONLY
AA SIZE
AA SIZE
AA SIZE
RANGE
ON-TIME
MIN MAX
OFF
TEST
1 MIN
5 MIN
Drip Loop
Forming a Drip Loop in the Solar Panel Cable
Wall Mount Eave Mount
5. Install 3 Ni-Cd rechargeable AA batteries
(included) into battery compartment according
to markings.
Note: Rechargeable batteries will
eventually lose their ability to hold a charge.
When this happens, replace with Ni-Cd or
Ni-MH rechargeable AA batteries available
at most stores.
Install Batteries in Battery Compartment
TEST AND ADJUSTMENT
Note: Sensor has a 30 second warm up period
before it will detect motion. When switching
modes wait 30 seconds.
1. Slide the sensor switch to the TEST position.
2. Place the RANGE adjustment in the medium
position (halfway between MIN and MAX
position).
RECHARGEABLE
ONLY
AA SIZE
AA SIZE
AA SIZE
RANGE
ON-TIME
MIN MAX
OFF
TEST
1 MIN
5 MIN
Controls in Battery Compartment
6. To adjust light direction, loosen lock nut and
rotate light to desired position. Tighten lock
nut.
Turning Lock Nut
Lock Nut
NOTICE: When replacing rechargeable batter-
ies, recycle used batteries or dispose of them
in accordance with local regulations.
RECHARGEABLE
ONLY
AA SIZE
AA SIZE
AA SIZE
RANGE
ON-TIME
MIN MAX
OFF
TEST
1 MIN
5 MIN