Filter
Top Products
21
English
(4) Remove the bolt and washer (D)
Fig. 33-a Fig. 33-b
(5) Lift the lower guard and mount the saw blade.
WARNING: When mounting the saw blade, confirm that the rotation indicator mark on the saw
blade and the rotation direction of the gear case (see Fig. 1) are properly matched.
(6) Thoroughly clean washer (D) and the bolt, and install them onto the saw blade spindle.
Fig. 33-c Fig. 33-d
(7) Press in the spindle lock and tighten the bolt by turning it to the left by standard accessorie’s wrench
(10mm box wrench) as indicated in Fig. 33-c.
CAUTION: * Confirm that the spindle lock has returned to the retract position after installing or
removing the saw blade.
* Tighten the bolt so it does not come loose during operation.
Confirm the bolt has been properly tightened before the power tool is started.
2. Dismounting the saw blade
Dismount the saw blade by reversing the mounting procedures described in paragraph 1 above.
The saw blade can easily be removed after lifting the safety cover.
CAUTION: Never attempt to install saw blades larger than 10" (255mm) in diameter.
Always install saw blades that are 10" (255mm) in diameter or less.
MAINTENANCE AND INSPECTION
WARNING: To avoid an accident or personal injury, always confirm that the trigger switch is turned
OFF and the power plug has been disconnected from the receptacle before performing
any maintenance or inspection of this tool.
1. Inspecting the saw blade
Always replace the saw blade immediately upon the first sign of deterioration or damage.
A damaged saw blade can cause personal injury and a worn saw blade can cause ineffective operation
and possible overload to the motor.
CAUTION: Never use a dull saw blade. When a saw blade is dull, its resistance to the hand
pressure applied by the tool handle tends to increase, making it unsafe to operate
the power tool.
Spindle Lock
10mm Box Wrench
Spindle Cover
4mm Machine Screw
Washer (D)
6mm Bolt
Bolt
Washer
Saw Blade
Washer (D) (Chamfering side)
Washer (D)
5/8" (15.9mm)
01e_c10fch_e.p65 1/30/04, 17:5821