Filter
Top Products
English
—
10
—
BEFORE OPERATION
Read section titled “SAFETY” (pages 4 – 6).
Make sure of the followings before operation.
WORKING ENVIRONMENT
WARNING
● No flammable gas, liquid or other flammable objects at worksite.
● Clear the area of children or unauthorized personnel.
AIR SUPPLY
DANGER
● Never use oxygen, combusti-
ble gases or any other bot-
tled gases.
WARNING
● Never connect Stapler to pressure which potentially exceeds
200 psi (13.7 bar 14 kgf/cm
2
).
● Never use non relieving coupler on Stapler.
1. Power source
⅜ Use only clean, dry, regulated compressed air as a power source for this Stapler.
⅜ Air compressors used to supply compressed air to this Stapler must comply with the
requirements of the latest version of ANSI Standard B 19.3 “Safety Standard For
Compressors For Process Industries.”
⅜ Moisture or oil in the air compressor may accelerate wear and corrosion in the Stapler.
Drain daily.
2. Filter-Regulator-Lubricator
⅜ Use a regulator with a pressure range of 0 – 120 psi (0 – 8.3 bar 0 – 8.5 kgf/cm
2
).
⅜ Filter-regulator-lubricator units supply an optimum condition for the Stapler and extend
the Stapler life. These units should always be used.
Filter ................. The filter removes moisture and dirt mixed in compressed air.
Drain daily unless fitted with an automatic drain.
Keep the filter clean by regular maintenance.
Regulator ......... The regulator controls the operating pressure for safe operation of the
Stapler.
Inspect the regulator before operation to be sure it operates properly.