Hitachi NR-7000 Welding System User Manual


 
Prohibited
Do not use this product near flammable
substances (gasoline, benzine, thinner, etc.).
(Cause of explosion or fire)
Never use this product together with other
beauty treatment devices at the same time.
(Cause of a failure or trouble)
Never use this product if there is some wound
or inflammation on your lips.
(Cause of lip trouble or pain)
Do not drop this product, or give it a strong
impact. (Cause of injury or a failure)
Disassembly
prohibited
Never modify this product. Only a qualified
technician may make repairs. (Cause of a fire,
electric shock, injury, or failure)
Check the head for any damage or
deformation before use. (Cause of lip damage)
Make sure
Failure to observe the following will cause
injury or a failure due to heat generation,
battery leakage, or bursting of the battery.
- Correctly use the battery according to the indication for use.
- Perform periodic inspection (for battery leakage).
- When not using this product for one month or more, take out
the battery.
Remove accessories, such as earrings and
necklaces, and contact lenses for use.
(Cause of accidents or trouble)
If there is any severe roughness or chapping
of your lips, you may feel strong irritation in
rare instances. In this case, do not use this
product. (Cause of lip trouble or pain)
When there is someone around, use this
product paying attention to unexpected
movements. (Cause of injury)
Do not keep the cotton swab or heating head
on one part of your lips but always keep it in
motion. (Cause of lip trouble or poor physical
condition)
Names of parts and their functions (Fig.1)
Upper cap
For the heating head. Make sure to put it on after use.
(II) Heating mode indication lamp (orange)
This lamp flashes during preparation and lights upon
completion of preparation.
Switch
If this switch is pressed, an operating sound will be heard,
and the cleansing mode indication lamp will light.
If this switch is pressed again during cleansing, switching
to heating care will be performed.
- Every time the switch is pressed, an operating sound
will be heard, and the mode will be switched (in order
of cleansing – heating – OFF – cleansing).
Main body
Main body case
Remove it when setting a battery.
Rubber head
Set a cotton swab.
The rubber head section can be removed from the main
body and cared for.
Locating hole
The position to cut a cotton swab can be determined.
Heating head
The surface is warmed up by the built-in heater.
(I) Cleansing mode indicating mode (green)
This lamp lights during cleansing.
Grounding parts
Ion cleansing cannot be performed unless one of these
parts is touched for use.
* The switch is not a grounding part.
Lower cap
For the rubber head. Make sure to put it on after use.
Attachment
Toner tray
What is ion cleansing?
Cosmetic products such as lipstick and lip gross remaining
on lips that are hard to remove by usual cleansing or face
washing are drawn out by using electrical properties.
- This is not a makeup remover.
What is heating care?
By moving the warm heating head, lips and lip balm are
softened in order to permeate deeply into wrinkles.
Precautions for use
Do not wash this product with water. And, do not soak in
water or splash water on it. (Cause of a failure)
Do not use or leave this product in places splashed with
water or in damp places, such as in a bathroom.
(Cause of a failure or short circuit)
Make sure to put on the caps after use.
(Cause of injury or a failure)