Hitachi NR-7000 Welding System User Manual


 
(3) Insert the cut cotton swab until the cotton head
comes in contact with the rubber head. (Fig.10)
Notice
Use a commercially available cotton swab.
Cotton swabs having an extremely narrow stem (for
babies, etc.) and those having a thick stem (long-
stemmed for medical use, etc.) may not be able to be set.
Cotton head
How to use
Step I Ion cleansing mode
Do not use this product with the rubber
head off. (Cause of a failure)
When feeling pain or disorder during use
of this product, or sensing anything
wrong with your lips after use, stop using
this product and consult a dermatologist.
(Cause of lip trouble, etc.)
Use this product only for lips and their
peripheries (outline).
(Cause of accidents or trouble)
Never use this product if there is some
wound or chapping of your lips.
(Cause of lip trouble or pain)
1. Insert the cut cotton swab with toner to the rubber head.
Use your regular toner. (Do not use a milky lotion or gel.)
Pour a small amount of toner into the attached toner
tray, and dampen the entire cotton head with enough
amount of toner. (Fig.11)
Some toners (made only of mineral spring water or
water, etc.) may not show effects sufficiently.
CAUTION
Ion cleansing cannot be performed if the cotton
head dampened with toner is not in contact with the
rubber head. (Fig.12)
Cotton head
The cotton head should be in contact with the
rubber head.
2. Press the switch.
Your will hear an operating sound (single short beep),
the cleansing mode indication lamp (green) will light,
and you will hear a motion sound (repeated short beeps).
(Fig.13)
Way to hold (Fig.15)
3. Hold the main body so as to touch one of the grounding
parts of the main body.
Grounding parts
Hold so as to touch one of them.
Be careful not to touch the switch.
4. Lightly apply the cotton head to your lips, and gently
move it.
(1) Move the cotton head vertically along vertical
wrinkles on your lips. (Fig.16)
(2) Open your lips as pronouncing “e,” and move up
and down around the corners of the mouth.
(Fig.17)
(3) Finally, move the cotton head and slide it all over
your lips. (Fig.18)
Do not keep the cotton head on
one part of your lips but always keep
it in motion. (Cause of lip trouble or
poor physical condition)
If the moisture in the cotton head becomes
insufficient or if it is hard to slide, replenish the toner.
Do not use on one part of your lips for more than 10
seconds.
If you feel a slight current stimulation (a tingling
sensation) during use, replenish the toner.
CAUTION
Avoid putting the cotton head inside your oral cavity.
5. An automatic stop is made when 2 minutes have
elapsed. (Auto-off function)
To stop using in mid-process, turn the switch OFF by
pressing it twice.
If an automatic stop is made, an ending sound
(double beep) will be heard.
CAUTION
Avoid continuous use.
It will strain your lips and cause lip trouble.
6. Remove the cotton swab from the main body. (Fig.19)
After use, wipe away the toner adhering to the rubber
head and main body with tissue paper, etc.
CAUTION
Be careful not to detach the rubber head.
(Cause of loss)
Do not reuse the cotton swab once it is used.
(Cause of lip trouble)
Make sure to wipe away the toner adhering to the
main body. (Cause of a failure by entry of toner
into the main body)
Ion cleansing cannot be performed unless one of the
grounding parts of the main body is touched. (Fig.14)
If you are worried about dryness after cleansing, use
the heating care mode.