Hitachi Koki USA N 5024A2 Staple Gun User Manual


 
English
SAFETY — Continued
WARNING
— 7 —
17. KEEP FACE, HANDS AND FEET AWAY
FROM FIRING HEAD AT ALL TIMES.
Never place your face, hands or feet near
the firing head.
18. PLACE STAPLER PROPERLY ON
WORKPIECE.
Do not drive fasteners on top of other
fasteners or with the Stapler at too steep
of an angle; the fasteners can ricochet
and hurt someone.
19. BE CAREFUL OF DOUBLE FIRE DUE TO
RECOIL.
If the push lever is unintentionally
allowed to re-contact the workpiece
following recoil, an unwanted fastener
will be driven.
In order to avoid this undesirable double
fire,
1)do not push the Stapler on the
workpiece with strong force;
2) take the Stapler completely away from
the workpiece using recoil, and keep
the push lever away from the
workpiece until the next desirable
shot; and
3) pull the trigger and release it QUICKLY
when performing intermittent
operation (trigger fire).
20. DO NOT DRIVE FASTENERS INTO THIN
BOARDS OR NEAR CORNERS AND
EDGES OF WORKPIECE.
The fasteners can be driven through or
away from the workpiece and hit
someone.
21. NEVER DRIVE FASTENERS FROM BOTH
SIDES OF A WALL AT THE SAME TIME.
The fasteners can be driven into and
through the wall and hit a person on the
opposite side.
22. CHECK FOR LIVE WIRES.
Avoid the risk of severe electrical shock
by checking for live electrical wires that
may be hidden by walls, floors or ceilings.
Turn off the breaker switch to ensure
there are no live wires.
23. NEVER CARRY STAPLER BY HOSE.
24. DO NOT OVERREACH.
Keep proper footing and balance at all
times.
25. NEVER USE STAPLER WHICH IS
DEFECTIVE OR OPERATING
ABNORMALLY.
If the Stapler appears to be operating
unusually, making strange noises, or
otherwise appears defective, stop using
it immediately and arrange for repairs by
a Hitachi authorized service center.
26. DO NOT DISCONNECT AIR HOSE FROM
STAPLER WITH FINGER ON TRIGGER.
The Stapler can fire when re-connected
to an air supply.
27. DISCONNECT AIR HOSE FROM STAPLER
WHEN:
1) doing maintenance and inspection;
2) loading fasteners;
3) clearing a jam;
4) it is not in use;
5) leaving work area;
6) moving it to another location; and
7) handing it to another person.
Never attempt to clear a jam or repair the
Stapler unless you have disconnected air
hose from the Stapler and removed all
remaining fasteners from the Stapler.
The Stapler should never be left
unattended since people who are not
familiar with the Stapler might handle it
and injure the themselves.
28. STAY ALERT.
Watch what you are doing. Use common
sense.
Do not operate the Stapler when you are
tired.
The Stapler should never be used by you
if you are under the influence of alcohol,
drugs or medication that makes you
drowsy.
01Eng_N5024A2_US 12/26/08, 11:067