Filter
Top Products
. A complete Parts List is available at www.HobartWelders.com
OM-926 Page 18
5-3. Trigger Safety Lock
1 Trigger
801 397-A
1
Trigger Locked Trigger Unlocked
801 400-B / Ref. 802 878
5-4. Plasma Cutting System Practices
Pulling rather than pushing the torch
makes cutting easier. Use a proper guide
or template for accurate cutting operations.
The pilot arc starts immediately
when trigger is pressed.
Maintain approximately a 90° angle to the
workpiece surface for proper cutting results.
Always connect work clamp to a clean,
paint-free location on workpiece, as close to
cutting area as possible.
. Set correct air pressure for process:
75 PSI (517 kPa) for cutting,
55 PSI (379 kPa) for gouging.
90°
DO NOT start pilot arc without cutting or
gouging as this shortens the service life
of the nozzle and electrode.
Sparks should pass through the workpiece
and out the bottom when cutting.
If sparks flare back from surface, this
usually is an indication that either travel
speed is too fast or amperage is set too low.
When doing extended (non-shielded)
cutting, maintain approximately 1/8 in
standoff between electrode and surface.
1/8 in
(3.2 mm)
DO NOT put pressure on shield when
drag cutting; instead, slide shield along
the surface for proper cutting results.
Wt