Filter
Top Products
OM-184 693 Page 6
2-4. Installing Wire Spool And Threading Welding Wire
150 436-A
1 Top Cover
2 Canister
3 Canister Cover
4 Thumbscrew (Canister
Cover)
Loosen thumbscrew and remove
cover.
5 Wire Spool
Loosen wire from spool, cut off
bent wire, and pull 6 in (150 mm) of
wire off spool.
6 Pressure Roll Assembly
Lift arm and open pressure roll
assembly.
7 Canister Inlet Guide
8 Drive Roll Groove
For wire sizes .035 in (0.9 mm) and
smaller use small groove, and
.047 in (1.2 mm) and 1/16 in
(1.6 mm) use large groove.
9 Contact Tip
Thread wire through canister inlet
guide, along drive roll groove, and
out contact tip.
Install spool so wire feeds off
bottom.
10 Spool Brake Thumbnut
If necessary, turn thumbnut coun-
terclockwise slightly to install
spool.
11 Thumbscrew (Canister
Rotation)
Loosen thumbscrew to rotate can-
ister (see Section 2-5).
Close and secure pressure roll
assembly.
Reinstall top cover and canister
cover.
Tools Needed:
9
1
2
10
3
4
5
6
7
8
11
2-5. Rotating Canister
150 433-A
1 Canister
Loosen canister rotation thumb-
screw (see Section 2-4). Move
canister to desired position. Tight-
en thumbscrew.
1
Rear View