Filter
Top Products
OM-184 693 Page 11
4-3. Gun Drive Assembly Maintenance
Ref. 149 967-C / Ref. 800 945-A
Retract wire onto spool.
1 Setscrew
2 Current Pick-Up Tab
This tab helps prevent burnback
caused by welding arcs inside the
contact tip. This tab may be re-
moved to provide an insulated
drive roll. (If tab is removed, a
smaller diameter contact tip is rec-
ommended. See options in Parts
List.) Lightly grease top of tab be-
fore reinstalling.
3 Drive Roll
Use wire brush to clean drive roll.
Install drive roll with desired groove
down, and turn drive roll so one
setscrew faces flat side of shaft.
4 Bearing
Use wire brush to clean bearing.
Line up drive roll groove with bear-
ing groove and liner opening.
Tighten setscrews.
Thread welding wire through gun
(see Section 3-3). Close and se-
cure pressure roll assembly. Adjust
drive roll pressure, if necessary
(see Section 3-8). Reinstall top
cover.
Tools Needed:
5/16 in
3
1
2
4