Filter
Top Products
OM-314 Page 12
2-7. Connecting To Weld Output Terminals
ST-800 052-A / Ref. S-161 415
For DC Weld Output
1 Negative (–) Weld Output
Terminal
2 Positive (+) Weld Output
Terminal
For Electrode Positive (DCEP),
connect work cable to Negative (–)
terminal and electrode holder cable
to Positive (+) terminal.
For Electrode Negative (DCEN),
reverse cable connections.
For AC Weld Output
3 Work Weld Output Terminal
4 Electrode Weld Output
Terminal
Connect work cable to Work
terminal and electrode cable to
Electrode terminal.
Close access door.
Y Use only one set of terminals
at a time. Range Selector
switch S2 is only high/low
range; both sets of output
terminals are energized all
the time.
Tools Needed:
12
34
3/4 in
Route weld cables under bar.