Filter
Top Products
32
5) Under the front of the machine, and
in front of the Accessory Disks [P], find
and remove the two M8 Capscrews,
Lockwashers, and Washers that match
the pattern in the Nozzle Bracket
Assembly (Not Shown). Remove these
Capscrews, Lockwashers, and Washers
from the machine. This hardware was
used only to plug holes in the gearbox.
6) Using the two (2) M8 Capscrews,
Lockwashers, and Washers supplied
in the kit, mount the Nozzle Bracket
Assembly with the hose barb fitting
toward the rear of the machine.
7) Take the free end of the Water Tank Hose
and slide a Hose Clamp [QQ4] loosely over
the hose. Route the hose through the side
of the machine [See FIG. 1] and the opened
Dust Port Cover [FIG. 31]. Attach the hose
to the Hose Barb fitting on the Nozzle
Bracket Assembly.
8) Slide the Hose Clamp down the hose until
it is on the Hose Barb fitting at the Nozzle
Bracket. Tighten the M6 Capscrew, and
Lockwasher that hold the Hose Clamp [QQ4].
9) Install two (2) more
Hose Clamps [QQ4]
along the frame [See FIG. 1].
10) Make sure the Water Valve [QQ1] is closed
before adding any water to the water tank.
WARNING: DO NOT lift the machine into the air
if the Water Tank is filled with water. This added
weight will cause the balance point to be shifted
so that the machine will not lift in a horizontal
position.
11. Repairs
12. Spare Parts
We carry out all repairs in the shortest possible time
and at the most economical prices. See front cover for
our address and telephone numbers.
For a quick supply of spare parts it is essential to quote
the data shown on the Serial Number Plate [VV] [See
FIG. 13] fixed to the machine. Make note of this infor-
mation & the purchase date below, and on the front
cover of this document for quick reference:
Model:
________________
Serial No:
________________
Date:
________________