Filter
Top Products
11
Inserting Fuel Cell
Inserting the metering valve/fuel cell assembly into the
TrimMaster 18
™
Finish Nailer is very simple. To begin,
press up at the bottom of the actuator cover and pivot
outward to open. The cover will swing out of the way.
Next, with the metering valve stem pointed toward the front
of the tool, insert the metering valve/fuel cell assembly.
As you slide the metering valve/fuel cell assembly into the
TrimMaster 18
™
Finish Nailer, you will notice a yellow
adapter at the top of the cylinder pocket. As shown in the
illustration, this adapter is designed to ensure that the
metering valve stem is properly aligned with the small hole,
or orifice, that leads to the combustion chamber. Insert the
metering valve stem into the orifice of the yellow-colored
adapter.
Fuel Cell and Metering Valve
Close the actuator cover to complete the loading of fuel in
the TrimMaster 18
™
Finish Nailer. Do this by swinging it up
and over the fuel valve/cylinder assembly, and pushing
down until the actuator cover snaps into position.
➔
1. PRESS UP
➔
1. SWING BACK
Fuel Cell
Yellow
Adapter
Metering Valve Stem
Yellow Metering
Valve
2. PULL OUT
➔
2. PUSH DOWN
➔
P
P
P