Filter
Top Products
8
Battery and Charging System
Inserting Battery
1. Load the battery, contacts first, into the TrimMaster 18
™
Finish nailer.
2. Push battery fully forward into its locked position.
3. To remove battery, push down on locking tab and slide
battery out.
NOTE: If battery is left in tool for an extended period, the
battery will discharge completely and will require recharging.
IMPORTANT: Should your battery terminals become
corroded and cause poor electrical contact, clean the
terminals using a soft cloth.
Battery Indicator Light
On the right side of the handle is a small plastic lens. This
is the battery indicator light. When you insert a fully-charged
battery into the tool, you will see a blinking green light. If the
indicator light blinks red, recharge the battery.
BATTERY INDICATOR LIGHT
Clean the
contacts
P
P