Filter
Top Products
16
Servicing
Air Filter
Open the cover by pressing slightly above the adapter and
pivoting the cover open. The air filter simply lifts out.
Tap the filter GENTLY to remove any dust. Check and clean
the air filter every two days. Soap and water restores the
filter to a "like new" condition.
End-of-Workday Routine
These simple steps are based on maintaining the safety and
operational efficiency of the Impulse
®
18 Ga. Brad Nailer.
Before you leave the work site:
1. Remove battery and store in tool case. Always use the
TrimMaster 18
™
Finish Nailer
case for transporting and
storing the tool.
2. Dispose of all empty fuel cells. Remember to dispose of
these cells where they will not be crushed, punctured,
burned or found by children.
When you get home:
1. Place the battery in its charger if it needs charging as
indicated by the red charge light on the handle.
2. Wipe yourTrimMaster 18
™
Finish Nailer with a clean,
soft cloth.
3. Remove and clean the filter every two days.
4. Check work contacting element to ensure it is operating
freely.
Paslode Cordless Tool Accessories
A variety of accessories are available for the Impulse
®
18
Ga. Brad Nailer:
No-Mar Replacement Tip -Hard Tip Part No. 901048
No-Mar Replacement Tip -Soft Tip Part No. 901067
Battery - Part No. 404717
Extra battery allows use of one battery while spare battery
is being charged.
Tinted Safety Glasses - Part No. 402512:
Cuts glare while affording eye protection.
Clear Safety Glasses - Part No. 402510
Impulse
®
Oil - Part No. 401482
Battery Charger Kit - Part No. 900200
Automotive Adapter - Part No. 900507
TrimMaster 18
™
Finish
Nailer Case - Part No. 901058
High Altitude Valve Kit - Part No. 219247
Contact your Paslode
®
representative for additional
information.
Tools
A 9/64 Hex Wrench (Part No. 900736) is provided with
each TrimMaster 18
™
Finish Nailer .
COVER
FILTER
CAP