Filter
Top Products
6
Safety Instructions
12. NEVER DRIVE FASTENERS INTO AREAS WITH
CONCEALED HAZARDS.
Always check the area behind the work surface for
electrical wiring, gas pipes, water pipes, sewer drains or
other potential hazards.
13. ALWAYS MAINTAIN SECURE AND UNOBSTRUCTED
FOOTING WHEN ON LADDERS, PLATFORMS OR
OTHER HIGH LOCATIONS.
14. ALLOW ONLY QUALIFIED PERSONNEL TO OPERATE
THE TRIMMASTER 18
™
FINISH NAILER.
15. PROPERLY STORE FUEL CELL.
16. ALWAYS STORE THE TOOL WITH THE FUEL CELL
AND BATTERY REMOVED.
Store the fuel cell in the case with the TrimMaster 18
™
Finish Nailer.
17. KEEP THE TOOL CLEAN.
A clean tool is less likely to jam or malfunction.
18. KEEP YOUR HANDS CLEAR OF THE WORK AREA
SURFACE.
WARNING
Never over-reach, since
tool recoil may cause a
loss of balance. Always
be aware of edges and
drop-offs when nailing on
rooftops and other high
locations. Keep them in
full view.
WARNING
Only persons who have read
and fully understand all tool
operation safety and
maintenance instructions
should be allowed to operate
the tool.
WARNING
A fastener may exit at an
angle unexpectedly and
cause injury.
WARNING
Always store fuel cells
where they will not be
exposed to an open
flame, sparks or
temperatures above 120°
F (49° C).
Battery Disposal:
The Paslode batteries contains cadmium and must be recycled or disposed of properly. It is illegal in some areas
to place a nickel-cadmium battery into the trash or solid waste stream. You may contact your local recycling center
for information on where to return the spent battery or call 1-800-822-8837 for information on Ni-Cd battery recycling
in your area.