Filter
Top Products
6
90°
°°
° to the Table
1. Place the fence on the saw table and lock it.
2. Place a square on the table next to the
fence. The fence should be 90° to the table,
Figure 6.
3. If adjustment is necessary, unlock the
fence, and turn one of the two nylon
adjustment screws (A, Fig. 7) until the fence
is 90° to the table.
4. Lock the fence and check the adjustment
again.
Cursor Adjustment
1. Disconnect the table saw from the power
source.
2. Raise the saw blade above the tabletop.
3. Unlock the fence and slide it to
approximately four inches from the saw
blade.
4. Lock the fence.
5. Measure the distance between the saw
blade and the inside of the fence.
6. Adjust the cursor to read the distance just
measured and tighten the cursor assembly
to the fence.
7. Take a test cut and confirm the adjustment
is correct.
Note: If the cursor does not have enough travel
to give the correct measurement loosen the
guide rail and adjust as needed. If you still do
not get the correct measurement loosen the
front rail and adjust as needed. If you have to
adjust the front rail you will need to go through
the front rail assembly instructions again.
This adjustment must be checked whenever a
different blade is installed.
After installing the XACTA FENCE II™ press
the black plastic end caps into the openings of
the guide rail. There is also an end cap for the
fence, but this should already be installed.