Filter
Top Products
10
Connector Housing
5. Attach three support legs (A, Fig. 4) to the base
using six M8 x 16 hex cap bolts and six M8 flat
washers (B, Fig. 4). Hand-tighten only at this time.
6. Install the housing (A, Fig. 5) to two support
legs (B, Fig. 5) using four M8 x 16 hex cap bolts,
eight M8 flat washers, and four M8 hex nuts (C,
Fig. 5). Be sure hose opening faces fan housing.
Note: For model DC-1100BK only – Before
attaching third support bracket place the hanger
bracket (D, Fig.5) between the support bracket
and the housing.
7. Tighten all nuts and bolts at this time with a 13mm
wrench.
Hose
Referring to Figure 6:
8. Attach the hose (B) between the fan housing (A)
and the impeller housing (D) with two clamps (C).
Tighten the clamps to secure the hose.
This completes the Base Unit assembly. If you
purchased the DC-1100BK Dust Collector (filter bag
version), continue on the following page. If you
purchased the DC-1100CK Dust Collector (canister
filter version), proceed to Canister Kit Assembly
section on page 12.
Figure 4
Figure 5
Figure 6