Filter
Top Products
13
Electrical Connections
All electrical connections must
be done by a qualified electri-
cian. All adjustments or repairs must be done
with the dust collector disconnected from the
power source, unplugged. Failure to comply may
result in serious injury!
The DC-1100 (all models) dust collectors are rated at
115/230V, Prewired 115V. Use a plug and outlet
rated at least 20 amps. The circuit for the machine
should also be protected by at least a 20 amp circuit
breaker or fuse. Keep in mind that a circuit being
used by other machines, tools, lights, heaters, etc. at
the same time will add to the electrical load.
A dedicated circuit to the dust collector will give you
the best results since dust collectors are generally
used at the same time other tools are running.
Turning the Machine On & Off
This machine is intended for
indoor use only.
All Models
Before hooking up to the power source, make sure
that the switch is in the off position.
Turn the dust collector on by pressing the Start
button mounted next to the motor. Press the Stop
button to turn off the dust collector.
Remote Control (Optional Accessory)
The DC-RC RF Remote Power Control unit is
available as an optional accessory (contact Customer
Service by calling the number on the cover).
Important: The DC-RC Remote Power Control (SN
708636C) can be used for activating Dust Collection
units powered by 115V only up to 1-1/2HP. If your
dust collector is currently set up for 230V operation or
you choose to convert it to 230V at a later time, you
must purchase the DC-RC230 Remote Power
Control unit (SN 708636D).
Figure 12A Figure 12B
Dust Collector RF Remote
Power Control (Optional)
The DC-RC Remote Power Control (Figure 1) should
be used for activating Dust Collection units powered
by 115V only up to 1-1/2HP. The DC-RC Remote
Power Control unit is rated at 115V, Single Phase
only. Use an outlet rated at least 20amps. The circuit
for the device being controlled by the DC-RC should
also be protected by at least a 20 amp circuit breaker
or fuse.
Before hooking up to the power source, make sure
that the switch is initially in the off position on both
the dust collector and remote control unit (Figure 12).
Turning the DC-RC On & Off
This machine is intended for
indoor use only.
1. Plug the dust collector into the main unit
(Figure 13) and plug the main unit into the power
outlet.
To start a machine or device:
2. Turn the machine itself on.
3. On the main unit place the switch to the ON
position (Figure 12A). The red LED on the main
unit should light up.
4. Press the button on the remote control
transmitter (Figure 13) to turn the machine on.
5. To stop the machine, press the button on the
remote control transmitter again.
Figure 13
When the machine is running, it can be stopped by
placing the switch on the main unit in the off position
(Figure 13). To restart, repeat steps 3 and 4.