Filter
Top Products
12
Canister Ki
t
Assembl
y
If you purchased Model DC-1100CK Dust Collector,
this section describes the assembly and installation of
the contents of the Canister Kit (SN 708639B).
Canister Filter
1. Mount the handle onto the canister filter with two
M10 hex nuts, two M10 flat washers, and a M10
lock washer (Figure 9).
2. Mount the canister filter on top of the collector
housing (A, Fig. 5) and tighten the knobs on the
canister filter (Figure 9).
Collector Bag
3. Place the ring over the top of the plastic bag and
fold over the bag approximately three inches,
Figure 10.
4. Insert the snap ring (A, Fig. 11) of the collector
bag into the bottom of the housing at an angle.
5. Pull down on the ring to make sure it “seats” in the
housing.
Note: make sure the snap ring “snaps” into place
in the housing, and also that the plastic bag hangs
down approximately 3” so that there are no air
leaks.
Figure 9
Figure 10
Figure 11