Filter
Top Products
9
Filter Bag Installation – DC-650A/ARC
1. Thread an M6 hex nut onto the filter bag support
rod, followed by an M6 flat washer and M6 lock
washer (A, Fig. 5). Thread the support rod (B, Fig.
5) into the motor/fan housing and tighten nut
against the housing.
2. Place the retaining strap (C, Fig. 5) through the
loops on the filter bag and hang the filter bag from
the hook.
3. Secure bag to housing with retaining strap.
Note: The retainer strap should be tight enough to
provide a good seal.
Collector Bag Installation – DC-650A/ARC
1. Insert the snap ring of collector bag into the bottom
of housing at an angle, see Figure 6.
2. Pull down on the ring and bag to make sure it
“seats” in the housing.
After completing the filter bag and collector bag
installation, proceed to Electrical Connections.
Figure 5
Figure 6