Filter
Top Products
ControlPanel- JDP-20VS-3
High-Low Switch (A, Fig. 5) - the center position is
neutral. Turn to the right to select the low motor
speed. Turn to the left to select the high motor
speed.
Drill Tap Switch (8, Fig. 5) - the center position is
the off position. Push the switch to the left for the
drill function. Push the switch the right for the tap
function.
Power Indicating Lamp (C, Fig. 5) - indicates
power to the main panel when lit. This lampwill only
light up in the drill or tap mode.
Motor Start Button (D, Fig. 5) - activatesthe motor
in the drill or tap mode.
Tap Return Button (E, Fig. 5) - reverses the
spindle rotation and the tap withdraws. Works only
in the tap mode.
Emergency Stop Button (F, Fig. 5) - disconnects
the power to the motor. Reset the button by turning
90°.
Control Panel - JDP-20VS-1
On-Off Switch - turns power to the machineon and
off.
Changing Spindle Speeds
To change spindle speeds, turn the hand wheel (A,
Fig. 6) until the pointer shows the desired speed.
Speeds are approximate.
Adjusting the Depth Stop for Drilling
Adjust the zero reading on the scale by:
1. Lower the quill to the bottom of its stroke by
turning the handle (A, Fig. 7) counter-clockwise
until it stops and hold in that position.
2. Turn the knurled knob (8, Fig. 7) until the pointer
reads zero. .
3. To set the depth stop, turn the knurled knob (8,
Fig. 7) to the desired setting. The quill will now
only advance to this setting.
8
A
B
C
D
E
F
Fig. 5
A
Fig. 6
BJf~
A
Fig. 7