Filter
Top Products
3
Line
Fig. C
115Volt
230Volt
2
3
24
4
v
Line
Line
Line
Fig. D
Grounded Outlet Box
C"".~
GroundingBla~
longest of the 3 blades
Fig. E
As received from the factory, the JDP-20VS-1 drill press is ready to run at 230 volt operation (the JDP-
20VS-3 is 230V and cannot be changed). This drill press,when the wiring is changed to 115volt, is
intended for use on a circuit that has an outlet and a plug that looksthe one illustrated in Figure A. A
temporary adapter, which looks like the adapter as illustrated in Figure 8, may be used to connect this
plug to a two-pole receptacle, as shown in Figure 8 if a properly grounded outlet is not available. The
temporary adapter should only be used until a properlygrounded outlet can be installed by a qualified
electrician. This adapter is not applicable in Canada. The green colored rigid ear, lug, or tab,
extending from the adapter, must be connected to a permanent ground such as a properly grounded
outlet box, as shown in Figure 8.
Grounded Outlet Box
Grounding blade isthe
longest of the 3 blades
Fig. A
Grounding Means
~ Ad,p'oc-\,",
fl
Fig.B
4