Filter
Top Products
3
WARNING
• Read and understand the entire instruction manual before attempting assembly or
operation.
• These lathes are designed and intended for use by properly trained and experienced
personnel only. If you are not familiar with the proper and safe operation of a lathe, do
not use until proper training and knowledge have been obtained.
• Always wear approved safety glasses/face shields while using this machine.
• Make certain the machine is properly grounded.
• Before operating the machine, remove tie, rings, watches, other jewelry, and roll up sleeves
above the elbows. Remove all loose clothing and confine long hair. Do not wear gloves.
• Keep the floor around the machine clean and free of scrap material, oil and grease.
• Keep machine guards in place at all times when the machine is in use. If removed for
maintenance purposes, use extreme caution and replace the guards immediately.
• Do not over reach. Maintain a balanced stance at all times so that you do not fall or lean
against blades or other moving parts.
• Make all machine adjustments or maintenance with the machine unplugged from the power
source.
• Use the right tool. Don't force a tool or attachment to do a job which it was not designed for.
• Replace warning labels if they become obscured or removed.
• Make certain the main power switch is in the OFF position before connecting the machine to the
power supply.
• Give your work undivided attention. Looking around, carrying on a conversation, and "horse-
play" are careless acts that can result in serious injury.
• Keep visitors a safe distance from the work area.
• Use recommended accessories; improper accessories may be hazardous.
• Make a habit of checking to see that keys and adjusting wrenches are removed before turning
on the machine.
• Never attempt any operation or adjustment if the procedure is not understood.
• Keep fingers away from revolving parts and cutting tools while in operation.
• Keep belt guard in place and in working order.
• Never force the cutting action.
• Do not attempt to adjust or remove tools during operation.
• Always keep cutters sharp.
• Always use identical replacement parts when servicing.
• Never operate this machine under the influence of alcohol or drugs.
• Failure to comply with all of these warnings may cause serious injury.