Jet Tools HVBS-56M Saw User Manual


 
6
5. Attach a cross brace to the opposite end of
the bed using three 5/16”x1” hex cap bolts,
six 5/16” flat washers, and secure with three
5/16” hex nuts. Tighten the nut on the end
of the bed first followed by the nuts on the
sides.
6. Attach a leg to the cross brace using four
5/16”x3/4” carriage bolts, four 5/16” flat
washers and four 5/16” hex nuts. Use a
12mm wrench to tighten. Repeat for other
leg.
7. Attach the adjustable feet (A, Fig. 2) to the
legs opposite of the motor, using the
provided hardware.
8. Slide the axle (A, Fig. 3) through the legs.
Place a large flat washer (B, Fig. 3) on both
sides of the wheels and place on the axle.
Secure wheels with two split pins (C, Fig. 3).
9. Carefully turn the saw onto its stand and
adjust the feet so the bed is level.
10. Put the handle (A, Fig. 4) through holes in
the stand legs opposite of the wheel
assembly and secure with split pins.