Filter
Top Products
7
Contents of the Shipping Container
1. Sander
3. Table Insert Rings
2. Spindle Wrenches
1. 2mm Hex Wrench
10 Removable Spindles
1/4” x 5” Steel and Sanding Sleeve
3/8” x 6” Steel and Sanding Sleeve
1/2” x 6” Steel and Sanding Sleeve
5/8” x 6” Steel and Sanding Sleeve
3/4” x 9” Steel and Sanding Sleeve
1” x 9” Rubber and Sanding Sleeve
1-1/2” x 9” Rubber and Sanding Sleeve
2” x 9” Rubber and Sanding Sleeve
3” x 9” Rubber and Sanding Sleeve
4” x 9” Rubber and Sanding Sleeve
1 Owner's Manual
1 Warranty Card
Tools Required for Assembly &
Adjustments
1. 26mm Wrench or Large Adjustable Wrench
1. 6mm Hex Wrench
1. Square
WARNING
Read and understand the entire contents of
this manual before attempting assembly or
operation of the sander!
Failure to comply may cause serious injury!
Unpacking
1. Remove all contents from shipping carton.
2. Report any damage to your distributor.
3. Do not discard any shipping material until
the sander has been assembled and is
running properly.
4. With help from another person move the
sander off of the pallet and into the desired
position.
5. Remove the protective coating found on the
table with a putty knife and a cleaning
solvent that will not damage painted
surfaces.
Note: Now is a perfect time to set your sander
up on a mobile base. It will make life easier in
the woodshop. JET has a Heavy Duty Universal
Mobile Base that will fit this sander. JET also
has a variety of Dust Collectors and Air Filtration
Units that will work nicely with your new sander.