Filter
Top Products
10
Assembly
Read and understand all
assembly instructions before attempting
assembly! Failure to comply may cause
serious injury!
Unpacking and Cleanup
1. Remove all contents from the shipping carton.
Keep the saw table upside down (see Figure
5) and place on a two-by-four or similar piece
of wood under the rear of the saw. This will
help when picking up the table again. Do not
discard the carton of packing material until the
saw is assembled and is running satisfac-
torily.
2. Inspect the contents for shipping damage.
Report damage, if any, to your distributor.
3. Compare the contents of the shipping carton
with the contents list in this manual. Report
shortages, if any, to your distributor.
Installing Legs
Referring to Figure 5:
1. Mount the four steel legs (A) to the cabinet
using M6x12 button head socket screws (B).
2. Install a foot (C) on the bottom of each leg,
using two M6x16 hex cap screws, M6 flat
washers and M6 hex nuts (D) for each foot.
Hand tighten only.
3. Turn saw right side up and allow the feet to
adjust to the floor surface. Tighten hex nuts.
Blade Tilt Pointer
Referring to Figure 6:
Secure the blade tilt pointer on the front of the
saw onto the bracket with an M4 screw and
tighten with a cross-point screwdriver.
Handwheels
Referring to Figure 7:
The JPS-10TS Table Saw comes equipped with
two handwheels which look identical except for
the mounting holes as follows:
1. On the front of the table saw slide the bushing
(B) onto shaft (A) followed by the handwheel
(C) with the larger mounting hole, making
sure to line up the flat side in the hole with the
flat side on the shaft.
2. Fasten in place with lock knob (D).
Figure 5
Figure 6
Figure 7