Filter
Top Products
10
7. Place motor over rubber grommets and
fasten to stand top with four hex cap
screws, eight flat washers, four lock
washers, and four hex nuts, as shown in
item C, page 7. See Figure 4. The
arrangement of these fasteners is shown in
Figure 5. Do not tighten at this time.
8. Align the motor pulley with the large pulley
using a straight edge against the flat sides
of the pulleys, as shown in Figure 6. The
pulleys should lie in a straight plane (Figure
7). Slide the motor as needed to align the
pulleys. If further adjustment is required,
loosen the set screw in one or more of the
pulleys and move the pulley(s) until they line
up. Tighten set screw(s).
IMPORTANT: When moving the pulleys, do
not position them beyond the end of the
shaft. Both pulleys must fully engage the
shaft and the key.
Figure 4
Figure 5
Figure 6
Figure 7