Filter
Top Products
7
Shipping Contents
Remove all contents from the shipping carton. Do
not discard the carton or packing material until the
band saw is assembled and is running
satisfactorily.
Compare the contents of the carton against the list
of parts in Contents of Shipping Container (below).
The letter identification in the list corresponds to the
items shown at right. This is your key for identifying
the parts used throughout the Assembly section for
easy reference.
Remove the protective coating that is applied to the
table with a house hold grease and spot remover.
Contents of Shipping Container
01 Band Saw (A)
01 Table Insert (B)
01 Table (C)
01 Miter Gauge (D)
01 Fence (E)
01 Rail Guide (F)
04 Stand Leg (G)
02 Short Support Plate (H)
02 Long Support Plate (J)
01 Owner's Manual (not shown)
01 Warranty Card (not shown)
01 Hardware Bag (see below for contents)
Contents of Hardware Bag
(p/n JWBS10OS-HB)
01 Hex Wrench 3mm (K)
01 Combination Wrench 10/13mm (L)
04 Rail Lock Knob (M)
04 Rubber Foot (N)
01 M6x32 Hex Cap Screw (O)
04 M6x12 Hex Cap Screw (P)
16 M8x16 Carriage Bolt (Q)
20 M8 Flat Washer (R)
16 M8 Hex Nut (S)
01 M6 Hex Nut (T)
04 M6 External Tooth Lock Washer (U)
Tools Required for Assembly & Adjustments
The tools listed below are not included but are
required for assembly.
2 14mm Open End Wrench
1 Cross Point Screw Driver
1 Combination Square
Shipping Contents