Filter
Top Products
8
Assembly
Front
Back
A
G
L
K
Q1
R1
S1
Q3
Q2
R2
S2
R3
S3
Figure 1
Stand
Referring to Figure 1:
1. Place the band saw (A) on its back as
shown above, either on the floor or
preferably on a workbench.
2. Assemble four legs (G) to the inside of the
base of the band saw, securing each leg
with two ea. M8x16 carriage bolts (Q
1), M8
flat washers (R
1) and M8 hex nuts (S1).
Hand-tighten only at this time.
3. Attach a long plate (L) to the rear legs as
shown in Figure 1. Secure with 2 ea M8x16
carriage bolts (Q
2), M8 flat washers (R2),
and M8 hex nuts (S
2). Hand-tighten only at
this time.
4. Attach the remaining long plate to the front
legs in the same manner described above,
hand-tightening only
5. Attach two short plates (K) to the right legs
and left legs in the same manner. Secure
each leg with 2 ea M8x16 carriage bolts
(Q
3), M8 flat washers (R3), and M8 hex nuts
(S
3). Hand-tighten only at this time.
6. Slip rubber feet (Figure 2) onto the ends of
the stand legs.
Figure 2
7. Place the saw and stand upright on a level
surface. Make sure that all four legs are
contacting the surface.
8. Tighten all nuts with a 13mm socket or
wrench.
Table Installation
Referring to Figure 3:
1. Loosen lock knob (C
2) and pull extension
(C
1) out from the table (C).
2. Orient the table (C) as shown, then
maneuver to allow the saw blade (A
2) to
pass through the slot (C
3) to the center.
3. Line up four threaded mounting holes
underneath the table (C) with the four
mounting through-holes on the trunnion (A
1).
Important: Adjust table so miter slot (C
4) is
parallel with saw blade (A
2).
4. Secure with four each M6x12 hex cap
screws (P) and M6x12 external tooth lock
washers (U).
5. Tighten the screws (P) with a 13mm wrench.
Figure 3