Filter
Top Products
13
Wear Adjustment in Tilting Mechanism
1. Disconnect the saw from the power
source.
2. Loosen lock nut (A, Fig. 15).
3. Turn eccentric sleeve (B, Fig. 15) until play
is removed. Flat area on sleeve
accommodates a wrench.
4. Tighten lock nut.
Electrical Connections
The JWCS-10A table saw is rated at
115V/230V, prewired 115V.
WARNING!
All electrical connections must be done by a
qualified electrician!
Failure to comply may result in serious
injury!
• To turn on power to the saw, press the
green start button on the switch assembly
box.
• To turn off power to the saw, press the red
stop button on the switch assembly box.
In the event the saw stops operating due to the
motor over heating, wait until the motor cools
down, push the reset button on the motor,
and press the green start button to start the saw
again.
Extension Cord Recommendations:
12 Gauge Cord - up to 25'
10 Gauge Cord - up to 50'
8 Gauge Cord - up to 100'
Note: Using extension cords can cause a loss
of power to your machine. It is best if the saw is
plugged directly into an outlet, or a short heavy
gauge extension cord is used.
Changing Belts
1. Disconnect the saw from the power
source.
2. Lower blade completely.
3. Lift the motor while taking the belts off the
motor pulley.
4. Let the motor hang from the bracket and
remove the belts from the arbor pulley.
5. Replace both belts.