Filter
Top Products
Operating the Generator
18 Operator’s Manual
OPERATION
Electric Start
NOTE: Read Operator’s Manual carefully before operating this
unit. Always make sure the unit is level and properly
grounded. Check engine oil before starting.
1. Open fuel valve on unit or engine. (See Fig. 3)
2. Turn the idle control switch to the OFF position.
(See Fig. 4)
3. Move choke lever to full choke. If re-starting a warm engine,
the choke should be left in the off position. (See Fig. 5)
4. Turn the engine ignition switch to the ON position.
5. Start the engine by turning the key switch fully clockwise
until the engine starts, then release the switch.
NOTE: Do not crank the engine continuously for more than
30 seconds at a time. If the engine does not start, allow
for a 3 minute cool down period between starting
attempts. Failure to follow these guidelines can damage
the starter motor.
If the starter does not turn the engine over, shut off
the starter immediately. Do not make further attempts to
start the engine until the condition is corrected. Do not
jump start using another battery.
6. Once engine has started, slowly move choke lever to no
choke.
7. Allow the unit to run for two (2) minute warm-up.
8. Turn main breaker to ON position (AC-G6010 units only).
9. Test the GFCI receptacle(s) on the unit. Push the test button.
The reset button should pop out and there should be no
power at the receptacle. Apply a test load or lamp to each
receptacle to verify. IF THE RESET BUTTON DOES NOT
POP OUT, DO NOT USE THE RECEPTACLES(S). SEE
DEALER FOR SERVICE IMMEDIATELY.
10. If GFCI receptacle(s) test correctly, rmly push the reset
button to restore power. A distinctive click should be heard or
felt when this is complete. IF THE RECEPTACLE(S)
DO NOT RESET PROPERLY, DO NOT USE THE
RECEPTACLE(S). SEE DEALER FOR SERVICE
IMMEDIATELY.
11. Turn idle control switch to ON position. Loads can now be
applied to unit.
NOTE: This engine is equipped with a “Low Oil” shutdown
system for engine protection. The engine stops when
the oil level gets too low. The engine will not restart
without adding oil. Refer to Preparing the Generator;
Engine Fuel Capacity for instructions on adding oil.