Filter
Top Products
Cordless Circular Saw Operator's Manual 15
Assembly
REMOVAL AND INSTALLATION OF BATTERY:
How to install the battery:
Align the battery with the groove in tool handle and slip it into
place. Always insert it all the way until it locks in place with a
little click. If not, it may accidentally fall out of the tool,
causing injury to you or someone around you. (Fig. 4)
How to remove the battery:
Withdraw battery from the tool handle while pressing the latch
on the front or sides of the battery. (Fig. 4)
CHARGING METHOD:
NOTE: Before plugging into the receptacle, make sure of
the following points. The power source voltage is
stated on the nameplate. The cord is not
damaged.
WARNING: DO NOT CHARGE AT VOLTAGE
HIGHER THAN INDICATED ON THE
NAMEPLATE. IF CHARGED AT
VOLTAGE HIGHER THAN INDICATED
ON THE NAMEPLATE, THE CHARGER
WILL BURN OUT.
1. Insert the plug of battery charger into the receptacle.
When the plug of battery charger has been inserted
into the receptacle, pilot lamp will blink in red. (At 1-
second intervals)
WARNING: DO NOT USE THE ELECTRICAL
CORD IF DAMAGED. HAVE IT
REPAIRED IMMEDIATELY.
2. Insert the battery to the battery charger. Insert the
battery into the battery charger as shown in Fig. 5.
Make sure it contacts the bottom of the battery
charger.
CAUTION: IF THE BATTERIES ARE INSERTED IN
THE REVERSE DIRECTION, NOT ONLY
RECHARGING WILL BECOME
IMPOSSIBLE, BUT IT MAY ALSO
CAUSE PROBLEMS IN THE CHARGER
SUCH AS A DEFORMED RECHARGING
TERMINAL.
(Fig. 4)
(Fig. 5)