Filter
Top Products
Cordless Circular Saw Operator's Manual 21
3. Cutting procedures:
CAUTION: RECHECK THAT THE SAW BLADE IS
SECURELY CLAMPED.
CONFIRM THAT THE WING-NUT FOR ADJUSTING
THE SLOT DEPTH, THE WING-BOLT FOR
ADJUSTING THE ANGLE OF INCLINATION.
a. Place the base on the material, then align the premarked
line and the saw blade with the guide piece front scale
section at the front of the base. (Fig. 13)
b. When the base is not inclined, use the large notch as the
guide piece. (Fig. 13, Fig. 14) If the base is inclined (45
degrees), use the small notch as the guide piece.
(Fig. 13, Fig. 15)
NOTE: When using the saw at the inclination of 45 degrees, use
both the marks of [45 degrees] on the bevel plate and
[45] on the inclined gauge of the base. (Fig. 16)
What’s more, if it is absolutely essential to use the saw
at a precise angle, make adjustment using a protractor,
etc.
c. Ensure that the switch is turned to the ON position
before the saw blade comes in contact with the lumber.
The switch is turned ON when the trigger is squeezed;
and OFF when the trigger is released. Moving the saw
straight at a constant speed will produce optimum
cutting.
CAUTION: BEFORE STARTING TO SAW, ENSURE THAT
THE SAW BLADE HAS REACHED FULL SPEED
REVOLUTION.
SHOULD THE SAW BLADE BE STOPPED OR MADE
AN ABNORMAL NOISE DURING OPERATION, TURN
OFF THE SWITCH IMMEDIATELY.
WHEN FINISHED WITH A JOB, PULL OUT THE
BATTERY FROM THE MAIN BODY.
TWISTING AND FORCIBLY PRESSING THE SAW
DURING CUTTING CAN RESULT IN UNREASONABLE
PRESSURE ON THE MOTOR, SO TRY TO GO
STRAIGHT SMOOTHLY.
IN THE SITUATION WHERE THE CIRCULAR SAW IS
CONTINUOUSLY OPERATED WHILE REPLACING
THE BATTERY WITH STOCKED SPARE
BATTERIES ONE AFTER ANOTHER, THE MOTOR
TENDS TO OVERHEAT. THEREFORE, WHENEVER
THE HOUSING BECOMES HOT, GIVE THE SAW A
BREAK FOR A WHILE.
AVOID CUTTING OPERATION IN A STATE WHERE
THE BASE BOTTOM IS AFLOAT FROM THE MATE
RAIL BEING CUT. OTHERWISE, THE MOTOR CAN
GET LOCKED.
Operation
OPERATION:
(Fig. 13)
(Fig. 14)
(Fig. 15)
(Fig. 16)