Filter
Top Products
24 Cordless Circular Saw Operator's Manual
Maintenance and Inspection
MAINTENANCE AND INSPECTION (CONTINUED):
4. Adjusting the base and saw blade to maintain perpendicularity:
The angle between the base and the saw blade has been adjusted
to 90°, however should this perpendicularity be lost for some reason,
adjust in the following manner.
a. Turn the base face up (Fig. 23) and loosen the wing-nut.
b. Apply a square to the base and the saw blade and, turning
the slotted set screw with a slotted-head screwdriver,
shift the position of the base to produce the desired
right angle.
5. Check for dust:
Dust may be removed with a clean rag or a cloth dampened with soapy water. Do not use
bleach, chlorine, gasoline or thinner, for they may damage the plastics.
6. Disposal of the exhausted battery:
WARNING: DO NOT DISPOSE OF THE EXHAUSTED BATTERY. THE BATTERY
MIGHT EXPLODE IF IT IS INCINERATED. THE PRODUCT THAT YOU
HAVE PURCHASED CONTAINS A RECHARGEABLE BATTERY. THE
BATTERY IS RECYCLABLE. AT THE END OF IT’S USEFUL LIFE, UNDER
VARIOUS STATE AND LOCAL LAWS, IT MAY BE ILLEGAL TO DISPOSE
OF THIS BATTERY INTO THE MUNICIPAL WASTE STREAM. CHECK
WITH YOUR LOCAL SOLID WASTE OFFICIALS FOR DETAILS IN YOUR
AREA FOR RECYCLING OPTIONS OR PROPER DISPOSAL.
STORAGE
Storing in a place below 104°F (40°C) and out of the reach of children.
SERVICE AND REPAIRS
All quality power tools will eventually require servicing or replacement of parts because of
wear from normal use. To assure that only genuine replacement parts must be used, all
service and repairs must be performed by a JOHN DEERE AUTHORIZED SERVICE
CENTER, ONLY.
STANDARD ACCESSORIES
WARNING: ALWAYS USE ONLY AUTHORIZED JOHN DEERE REPLACEMENT
PARTS AND ACCESSORIES. NEVER USE REPLACEMENT PARTS OR
ACCESSORIES WHICH ARE NOT INTENDED FOR USE WITH THIS TOOL.
CONTACT JOHN DEERE IF YOU ARE NOT SURE WHETHER IT IS SAFE
TO USE A PARTICULAR REPLACEMENT PART OR ACCESSORY WITH
YOUR TOOL.
THE USE OF ANY OTHER ATTACHMENT OR ACCESSORY CAN
BE DANGEROUS AND COULD CAUSE INJURY OR MECHANICAL
DAMAGE.
NOTE: Accessories are subject to change without any obligation on the part of the JOHN
DEERE.
1. Saw Blade (mounted on tool) 1
2. Box Wrench 1
3. Guide 1
4. Battery (EB1820 or EB18B) 1
5. Battery Charger (UC24YFA or UC24YF) 1
6. Plastic Case 1
External Diam. Hole Diam.
6-1/2” (165 mm) 5/8” (15.9 mm)
(Fig. 23)