Filter
Top Products
6 10-Inch Compound Miter Saw Operator's Manual
WARNING
CAUTION
FOR YOUR OWN SAFETY READ THIS INSTRUCTION MANUAL BEFORE OPERATING THE COMPOUND
MITER SAW
1. Always wear eye protection when using the compound miter saw.
2. Always keep hands out of the path of the saw blade.
3. Never operate the saw without the guards in place.
4. Never perform any freehand operation with the compound miter saw.
5. Never reach around the saw blade.
6. Always turn off tool and wait for saw blade to stop before moving workpiece or changing settings.
7. Always disconnect power before changing blade or servicing.
8. Saw blade diameter is 10" (255mm).
9. No load speed is 4900 min
-1
.
ALWAYS REMOVE ADJUSTING KEYS AND WRENCHES BEFORE STARTING TOOL
Always confirm that all keys and adjusting wrenches have been removed from the tool before it is turned on.
NEVER FORCE THE TOOL
It will do the job better and more safely if it is operated at the rate for which it was designed.
ALWAYS USE THE RIGHT TOOLS
Never force a tool or an attachment to do a job for which it was not designed.
ALWAYS MAINTAIN TOOLS WITH CARE
Always keep tools sharp and clean for the best and safest performance. Always follow instructions for lubricating
the tool and for changing accessories.
ALWAYS USE RECOMMENDED ACCESSORIES ONLY WHEN OPERATING THIS TOOL
Consult this instruction manual for descriptions of recommended accessories. To avoid personal injuries, use only
recommended accessories in conjunction with this tool.
ALWAYS CHECK FOR DAMAGED PARTS BEFORE USING THE TOOL
Always check the guard and all other components for damage before using the tool to assure that they will function
properly. Check all moving parts for proper alignment, free from binding and other conditions that might affect
proper operation. Always repair or replace any damaged guards or other damaged components before using the
tool.
ALWAYS CONFIRM THE ROTATION DIRECTION OF THE BLADE BEFORE USING THE TOOL
Always feed work into the tool against the rotation direction of the blade in order to prevent possible injury.
This tool was not designed to be used for mass-production applications and should not be used in mass-produc-
tion environments.
When servicing this tool, use only authorized replacement parts.
Apply 115 volts AC only to this tool. Applying the wrong voltage or applying DC power can cause the POWER
TOOL to operate improperly and cause serious personal injury or damage the tool.
Never raise the saw blade from the workpiece until it has first come to a complete stop.
Always use outboard stands to provide support for long workpieces that overhang the table of the compound saw.