Filter
Top Products
10-Inch Compound Miter Saw Operator's Manual 23
MAINTENANCE AND INSPECTION (CONTINUED):
STORAGE:
After operation of the tool has been completed, check that the following has been performed:
a. Trigger switch is in the OFF position.
b. Power plug has been removed from the receptacle.
c. Stored in a secure place.
When the tool is not in use, keep it stored in a dry place out of the reach of children.
LUBRICATION:
Lubricate the following sliding surfaces once a month to keep the power tool in good operating condition for a long
time. (see Fig. 1). Use of machine oil is recommended.
Oil Supply Points:
-Rotary portion of hinge
-Rotary portion of vise assembly
-Rotary portion of sub fence
CLEANING:
Periodically remove chips, dust and other waste material from the surface of the power tool, especially from the inside
of the safety cover with a damp, soapy cloth. To avoid a malfunction of the motor, protect it from contact with oil or
water.
SERVICE AND REPAIRS:
All quality power tools will eventually require servicing or replacement of parts because of wear form normal use. To
assure that only authorized replacement parts will be used and that the double insulation system will be protected, all
service (other than routine maintenance) must be performed by an AUTHORIZED JOHN DEERE DEALER.
NOTE: Specifications are subject to change without any obligation on the part of JOHN DEERE.
Maintenance and Inspection
WARNING: ACCESSORIES FOR THIS POWER TOOL ARE MENTIONED IN THIS INSTRUCTION
MANUAL. THE USE OF ANY OTHER ATTACHMENT OR ACCESSORY CAN BE
DANGEROUS AND COULD CAUSE INJURY OR MECHANICAL DAMAGE.
STANDARD ACCESSORIES:
1. 10" (255 mm) TCT Saw Blade 1 5. Holder 2
2. Dust Bag 1 6. Stopper 1
3. Vise Assembly 1
4. 10 mm Box Wrench 1
NOTE: Accessories are subject to change without any obligation on the part of JOHN DEERE.