John Deere ET-3403-J Saw User Manual


 
10-Inch Compound Miter Saw Operator's Manual 15
Operation
PRE-OPERATION (CONTINUED):
4. Oblique angle:
Before the power tool is shipped from the factory, it is adjusted for 0° and left 45° bevel cutting angles. The
positioning and bevel cutting angle can be adjusted by changing the height of the 8 mm bolt. (Maximum bevel
cutting angle is 45°).
5. Securing the workpiece:
WARNING: ALWAYS CLAMP OR VISE, TO SECURE THE WORKPIECE TO THE FENCE;
OTHERWISE THE WORKPIECE MIGHT BE THRUST FROM THE TABLE
AND CAUSE BODILY HARM.
6. Installing the holders:
The holders help keep longer workpieces stable and in place during the cutting operation.
a. As indicated in Fig.11, use a steel square for aligning the upper edge of the holders with the base surface.
b. After aligning, secure the holders with the 6mm wing bolts.
7. Stopper for precision cutting:
The stopper facilitates continuous precision cutting in lengths of 10" to 16-1/2" (255mm to 420mm). To install
the stopper, attach it to the holder with the 6mm wing bolt as shown in Fig. 12.
(Fig. 9)
(Fig. 10)
(Fig. 11)
(Fig. 12)