Filter
Top Products
1615
ASSEMBLY INSTRUCTIONS
Always remove battery pack before installing or removing blade.
When removing the blade from the tool, avoid contact with skin and use
proper protective gloves when grasping the blade or accessory. Accessories
may be hot after prolonged use.
If the blade clamp screw will not loosen enough to allow
blade installation, tap gently on the end of the wrench with a mallet until the
clamp screw breaks free.
ATTACHING / REMOVING BLADE
ATTACHING THE BLADE:
1. Remove the battery pack.
2. Retract the lower guard (see Fig. 1).
3. Slip the blade into place (see Fig. 2).
4. Put clamp washers and clamping
screw loosely in position.
5. Use the wrench to tighten the
clamping screw while pressing
down on the clamping knob
(see Fig. 3 and Fig. 4).
6. Remove wrench.
7. Replace the battery pack.
REMOVING THE BLADE:
1. Remove the battery pack.
2. Use the wrench to loosen the
clamping screw while pressing
down on the blade safety lock
button (see Fig. 3 and Fig. 4).
3. Remove the blade.
4. Tighten the blade clamp
screw back into place.
5. Remove wrench.
6. Replace the battery pack.
FIG. 1
FIG. 2
FIG. 3
FIG. 4
LOOSEN:
CLOCKWISE
TIGHTEN:
COUNTER-CLOCKWISE