Filter
Top Products
17
6. Apply pipe sealant to the threads of the brass connector. Use
pipe thread sealant that is certified for use with LP gas.
7. Use adjustable wrench to install brass connector (supplied) to
manifold fitting.
NOTE: The arrow on the regulator must be pointing toward
the brass connector.
8. Use pipe wrench to install the convertible regulator. Brass
cap will be facing up when tight.
9. To make sure the regulator is set for Natural gas, use
adjustable wrench to remove brass cap on appliance
regulator.
10. Examine the stem on the brass cap. If the letters “NAT” are
not showing on the end of the plastic stem farthest away from
the brass cap, remove stem from cap, turn it over and snap
stem back into the cap so the letters “NAT” are at the end of
the stem farthest away from the brass cap.
11. Reinstall cap onto convertible regulator.
Change the Power™ burner orifices
1. Remove the Power™ burner grate.
2. Remove the wok ring. Twist counterclockwise, lift, and set
aside.
3. Remove inner burner top ring from burner base.
4. Remove outer burner top ring from burner base.
5. Remove the burner base.
a. Lift rear of burner to remove locator pin from locator hole.
b. Gently pull the burner base to the rear to disengage the
burner from the gas valves and openings.
IMPORTANT: The igniter is connected to the burner base.
Make sure the wires do not get pulled from the ignition.
c. Rotate burner base 90° and place in the bottom of the
burner box.
6. Use a 7 mm socket and wrench or 7 mm nut driver to remove
the brass orifices from the gas valves.
A.Brass elbow
B.Convertible regulator
A
B
NAT
A.Inner burner
B.Outer burner
C.Burner base
A.Igniter wire
A.Inner burner
B.Outer burner
A
B
C
A
A
A
B