Filter
Top Products
20
Lighting Your Power™ Burner
1. Remove the Power™ burner cover. Do not light burners with
the cover on.
2. Do not lean over the Power™ burner.
3. Push in and turn the control knob for the inner or outer burner
to LITE/HI and hold in.
4. You will see the igniter glow. When burner is lit, release the
knob. Turn knob to desired setting.
5. Repeat for the other burner as needed.
IMPORTANT: If burner does not light immediately, turn the
burner knob to OFF and wait 5 minutes before relighting.
Manually lighting the Power™ burner
1. Remove the outdoor Power™ burner cover.
2. Remove the manual lighting extension (see following
illustration) and attach a match to the split ring.
3. Strike the match to light it.
4. Guide the match to the burner you wish to light.
5. Do not lean over the Power™ burner. Push in and turn the
burner knob to LITE/HI for the burner you wish to light. The
burner will light immediately. When burner is lit, turn knob to
desired setting.
6. Repeat for each of the other burners as needed.
7. Remove match and replace manual lighting extension inside
its holder.
IMPORTANT:
If burner does not light immediately, turn the burner knob to OFF
and wait 5 minutes before relighting.
If any burners do not light after attempting to manually light them,
contact the KitchenAid Customer eXperience Center. See the
“Assistance or Service” section.
WARNING
Burn Hazard
Do not let the burner flame extend beyond the edge of
the pan.
Doing so can result in burns.
WARNING
Food Poisoning Hazard
Do not let food sit for more than one hour before or
after cooking.
Doing so can result in food poisoning or sickness.