Filter
Top Products
11
Functions
Leica DISTO™ D3 760498a en
EN
F
E
P
Direct horizontal distance
Press this button twice and the following
symbol appears in the display .
Press this button to measure tilt and distance.
The summary line displays the result as the direct
horizontal distance.
Room corner angle function
The angles in a triangle can be calculated by
measuring the three sides. This function can be used
e. g. to check a right-angled room corner. See figure
{K}.
Press this button three times and the room
corner symbol appears in the display .
Mark the reference points to the right and left (d1/
d2) of the angle to be measured.
Press this button to measure the first (short)
side of the triangle (d1 or d2).
Press this button to measure the second (short)
side of the triangle (d1 or d2).
Press this button to measure the third (long)
side of the triangle (d3).
The result is displayed in the summary line as the
room corner angle.
Stake out function
Two different distances (a and b) can be entered into
the instrument and can then be used to mark off
defined measured lengths, e.g. in the construction of
wooden frames.
See figure {L}.
Entering stake out distances:
Press this button four times and the stake out
function symbol appears in the display .
The value (a) and the corresponding intermediate line
flash.
By using and , you can adjust the values
(first a and then b) to suit the desired stake out
distances. Holding the buttons down increases the
rate of change of the values.
Once the desired value (a) has been reached it can be
confirmed with the button.
The value (b) and the intermediate line flashes (the
defined value (a) is automatically adopted). Value (b)
can be entered using and .
The defined value (b) is confirmed with the
button.
Pressing the button starts the laser measure-
ment. The display shows required stake out distance
a
b
b