Filter
Top Products
55
206-4271
Cloning Procedures (Cont.)
(Continued from previous page)
Learning status will be shown in a pop-up progress banner at the bottom of the Learn From
TV (TLX) screen. This process may take a few minutes. Do NOT remove the USB device until
Learning is complete. When the Learning process is complete, a “Saving completed” message
is displayed.
9. Press OK to return to the Learn From TV (TLX) screen. To return to the TV Manager / USB
Download Menu, press on the Installer Remote or select BACK from the Learn From TV
(TLX) screen. To return to program viewing, select CANCEL.
10. Remove the USB memory device from the Master TV.
Note: If the Master TV has a channel lineup, during Learning, logical channel numbers
are automatically assigned in ascending order, starting with 0 (zero), to the physical RF
channels of the TV channel lineup to create an FTG Channel Map. See also note below.
Note: If the newly Learned TLX file is to be used for FTG Mode via CPU configuration
(i.e., it contains an FTG Channel Map), it is highly recommended that you open the file
in the FTG File Manager—BEFORE transferring (Teaching) the file to any Target TVs—
to verify FTG Channel Map and FTG Installer Menu settings and enable decryption by
marking Pro:Idiom encrypted channels. This will also enable you to confirm channels
and add channel attributes, labels, etc.
Teaching Configuration to a Target TV
This section describes how to transfer (Teach) a TLX le from a USB memory device to a TV using
the TV Manager / USB Download Menu “Teach To TV (TLX)” option. The TLX le may be created
either from a Master TV Setup that was saved (Learned) from a Master TV or in the FTG File
Manager.
Before You Begin
• Ensure the USB device has been formatted with FAT format.
• If you have initiated the EZ-Manager Wizard, you can use the wizard’s “USB Conguration”
option to access the TV Manager / USB Download Menu and complete the Teaching process,
if desired (see “TV Conguration Options” and/or “USB Conguration” on pages 15 and 21,
respectively, as necessary).
• You may also use the Ez Download utility to complete the Teaching process. See “Ez Download
Utility” on pages 31 to 34 for further information.
• If the Target TV is currently in Pass-through Mode and you intend to use the TV’s Zoning
feature(s)—i.e., the TLX le you are Teaching contains an FTG Channel Map and/or FTG
prole(s) with TV Zone and/or Wi-Fi Zone assignments—make sure to assign the appropriate
TV Zone # and/or Wi-Fi Zone # in the TV when directed to do so in the procedure below. See
Reference section, “Using the TV’s Zoning Features,” for further information.
• If you would like the Target TV(s) to remain in Pass-through Mode after Teaching, ensure the TLX
le does not contain an FTG Channel Map; otherwise, Teaching will result in the Target TV(s)
being congured for FTG Mode via CPU.
(Continued on next page)