Filter
Top Products
!"$&!
($&M%
$2.1.;1B;12?@A.;1A56@2;A6?2@20A6<;/23<?2
<=2?.A6;4F<B?:.056;2
%&+ %&$'&! %
&$%!0.;8699
• Do not touch electrically live parts such
as output terminals or internal wiring.
• Insulate yourself from the work and
ground.
• Always wear dry insulating gloves.
------------------------------------------------------------
------------------------------------------------------------
------------------------------------------------------------
------------------------------------------------------------
Only qualified personnel should operate this equip-
ment. Observe all safety information throughout this
manual.
------------------------------------------------------------
$%$"&!
The INVERTEC® 100S is a 100 amp arc welding
power source which utilizes single phase input power
to produce constant current output. The welding
response of this Inverter has been optimized for stick
(SMAW) welding.
)$
'% %%
0.;/21.;42?<B@
• Keep your head out of fumes.
• Use ventilation or exhaust to
remove fumes from breathing
zone.
$$+%
0.;/B?;
• Wear eye, ear and body
protection.
) '&& .;1
!' %"$%
0.;0.B@236?2<?2E=9<@6<;
• Keep flammable material away.
• Do not weld, cut or gouge on contain-
ers that have held combustibles.
) "&+
The INVERTEC® 100S is rated at 80 amps, 23.2
volts, at 20% duty cycle on a ten minute basis. It is
capable of higher duty cycles at lower output currents.
If the duty cycle is exceeded, a thermal protector will
shut off the output until the machine cools. See Table
A.1 in the %&&! Section for other rated out-
puts.
The INVERTEC® 100S is recommended for the fol-
lowing Electrode Types and Diameters:
*15 Amp Branch circuit or greater required.
20 Amp Branch circuit or greater required.
&&! %
The INVERTEC® 100S is not recommended for pipe
thawing.
&F=2@
Fleetweld 37
(E6013)
Fleetweld 35/180
(E6011)
Excalibur 7018 MR
(E7018)
*
-
-
*
-
-
*
*
*
-
-
%6G2@6;