Filter
Top Products
Vantage
®
300
www.lincolnelectric.com
[3]
A CLOSER LOOK
Key Controls
20
21
14
13
1211
10
1
5
6
8
9
18
17
16
1. Glow Plug Button
2. Weld Mode Selector Switch
3. Run/Stop Switch
4. Hour Meter
5. Start Pushbutton
6. Engine Idler Switch
7. Fuel Level, Engine Temperature and
Oil Pressure Gauges
8. Engine Protection Light
9. Engine Battery Charging Light
10. Circuit Breakers, except 240 VAC 3-Phase
11. 120 VAC GFCI Receptacles
12. 120/240 VAC Full-KVA 1-Phase Receptacle
13. 240 VAC Full-KVA 3-Phase Receptacle
14. 240 VAC 3-Phase Circuit Breaker
15. Covered Weld Output Terminals + and -
16. Ground Stud
17. 14-Pin Wire Feeder Connector
18. 6-Pin Remote Control Connector
19. Arc Force & Inductance/Pinch Control Dial
20. Welding Terminals Control Switch
21. Wire Feeder Voltmeter Polarity Switch
22. Digital Amps and Volts Output Meters
23. Output Control Dial
Note: Control panel door not shown.
FEATURES
23
22
19
2
4
15
3
7
Single-side engine access
with lockable sliding door.
Fuel, Oil Pressure and Engine
Temperature gauges help you
monitor performance.
Latched and lockable
radiator cap cover.
Convenient battery tray below
control panel.
Handy oil drain valve and tube
makes oil changes neat.
Output switches to remote
mode when remote device
is connected.
• Simple Controls – Keeps training time to a minimum. The flip-down
c
ontrol panel door keeps less frequently used dials out of the way.
Scratch-resistant Lexan
®
nameplate.
• Digital meters for amps and volts output make it easy to precisely set
your procedures.
• Large 15 gallon (57 liter) fuel tank provides run time for an extended
day–13 hours of welding at 300A/32V/100% duty cycle output, or 37
hours at high idle.
• Kilowatts available for Multi-Weld
™
350 use: 4.8 KW @ 60 VDC,
7.0 KW @ 58 VDC.
• Two Great Engine Choices – Kubota
®
V1505 or Deutz
®
D2008L4.
Both are 22 horsepower water-cooled 4 cylinder diesel engines. Both
engines also have an automatic idler for greater fuel economy and
reduced noise.
• Engine hour meter for scheduled maintenance.
• LN-25 PRO Arcoss-the-Arc wire feeder is a recommended option.
• 14-pin connector for Lincoln wire feeders with control cables:
LF-72, LF-74, LN-7, LN-8, LN-15, LN23P, LN-25, and LN-742. Also
compatible with Magnum
®
SG Spool Gun System.
• Two Vantage
®
300 units can be paralleled in the CC-Stick Mode to
increase output.