Filter
Top Products
A-7
INSTALLATION
WELD-PAK 3200HD
A-7
UNDERCARRIAGE ASSEMBLY
CYLINDER may explode
if damaged.
• Keep cylinder upright and secured
to support.
• Keep cylinder away from areas where it may be
damaged.
• Never lift welder with cylinder attached.
• Never allow welding electrode to touch cylinder.
• Keep cylinder away from welding or other live
electrical circuits.
• The undercarriage is not intended for transport-
ing the Weld-Pak 3200HD.
• If the Weld-Pak 3200HD is going to be transport-
ed, remove the under-carriage.
• Do not lift the Weld-Pak 3200HD when a gas bot-
tle is connected.
• If the Weld-Pak 3200HD is going to be moved or
lifted, remove the gas bottle.
------------------------------------------------------------------------
(Refer to Figure A.7)
Note: The following instructions assume a gas bottle
is going to be used. If a gas bottle is not going to be
used, skip steps 5 and steps 7-10.
1. Remove both sheet metal screws (1) from case.
2. Align undercarriage base (2) with side mount screw
holes as shown. Make sure the two caster mount-
ing holes are located in front of the machine.
3. Replace sheet metal screws removed in step 1
making sure to secure undercarriage to the Weld-
Pak 3200HD (1).
4. Use both supplied black round head screws to
secure door side of the Weld-Pak 3200HD (3) to
undercarriage.
5. Attach Gas Bottle Support Base to rear of undercar-
riage using supplied 1/4"-20 fasteners (4).
6. Attach the supplied fixed casters to the rear of the
undercarriage assembly (5).
7. Attach the supplied swivel caster to the front of the
undercarriage with the supplied 5/16" acorn nuts.
8. Attach both Gas Bottle Support Brackets (6) as
shown.
9. Insert gas bottle if available.
10. Tighten Gas Bottle Support Brackets with supplied
1/4"-20 wing screws and wing nuts.
FIGURE A.7
WARNING
1
2
3
4
5
6
7