Filter
Top Products
11
ACCESSORIES
11
OPTIONAL ACCESSORIES
K964-1 Undercarriage with Pivoting Single Gas
Cylinder Platform - This undercarriage features a piv-
oting platform to easily load and unload the gas cylin-
der without lifting. It was designed specifically for the
Square Wave TIG 175 power source, and accommo-
dates 7” to 9 1/4” diameter gas cylinders. The under-
carriage comes completely assembled and mounts
directly to the power source.
K870 Foot Amptrol™ - A foot operated remote current
control to be used while welding in 2 Step TIG mode.
In 4 Step TIG mode the Foot Amptrol acts as an Arc
Start Switch.
K812 Hand Amptrol™ - A thumb operated remote
current control to be used while welding in 2 Step TIG
mode. In 4 Step TIG mode the Hand Amptrol acts as
an Arc Start Switch.
K814 Arc Start Switch - The Arc Start Switch does not
provide remote current control. In 2 Step TIG mode the
Arc Start Switch allows on/off welding at the current set
with the Current Control on the control panel. The
Start/Crater Current and Downslope Time controls are
only active in 4 Step mode.
Magnum® LA-9 and LA-17 TIG Torches - The follow-
ing standard Magnum® TIG torches with one-piece
cable may be used with the Square Wave TIG 175.
• K859-1 LA-9 12.5 ft medium back cap
• K859-5 LA-9 25 ft medium back cap
• K860-1 LA-17 12.5 ft long back cap
• K860-5 LA-17 25 ft long back cap
NOTE: Each torch requires a Twistmate plug (S22529-
1) and strain relief boot (M17255) be installed onto the
cable. Collets, collet bodies, and nozzles are not
included and must be ordered separately.
Twistmate® Plug (S22529-1) and Strain Relief Boot
(M17255) - One of each is shipped with the welder to
connect any TIG torch with a right hand male 3/8-
24UNF-2B fitting. The Magnum LA-9 and LA-17
Torches are recommended. If you do not care to inter-
change these parts when using more than one torch
you may order additional sets. The Twistmate plug pro-
vides connection for both gas and welding current.
Tungstens, Collets, Collet Holders, Gas Cups,
Backcaps and Other Torch Parts - Standard
Magnum® parts and accessories for this torch may be
used when using a Magnum LA-9 or LA-17.
TIG Torch Parts Kits - Parts kits are available for the
LA-9 and LA-17 TIG torches. These kits include back
cap, collets, collet bodies, nozzles and tungstens.
Order KP507 for LA-9 torches
Order KP508 for LA-17 torches
See publication E12.150 for parts kits breakdown.
Cut Length Consumables - TIG welding filler metals
are available for welding stainless steel, mild steel, alu-
minum and copper alloys. See publication C9.10.
SQUARE WAVE TIG 175